Filter
Top Products
5
NOTE: To remove the trim ring from the tweeter housing:
1. Rotate the trim ring a few degrees in a clockwise
direction until you feel a detent.
2. Remove the trim ring by lifting it straight up.
INSTALLING THE TWEETER
SURFACE MOUNTING
Step 1: Determine the tweeter mounting location, then route the
wires from the crossover to the tweeter location.
Step 2: Place the surface mount housing against the panel and
mark the two holes at the rear of the housing.
Step 3: Drill the smaller center hole using a 1/8" drill bit. This is the
mounting screw hole.
Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a
grommet and route the speaker wire from the crossover
through the grommet.
Step 5: After removing the surface mount tweeter assembly trim
ring, route the tweeter wires through the larger hole in the
housing and connect to the speaker wires from the
crossover.
Step 6: Insert the excess speaker wire into the hole and position the
housing so the housing will not pinch the wires after final
mounting.
Step 7: Attach the housing using the supplied screws of the correct
length for a solid mount.
Step 8: Insert the tweeter into the housing and attach the trim ring.