Filter
Top Products
Alternate Microphones and Installation
•
19
Nothing comes close to a Cobra
®
Alternate Microphones
and Installation
18
English
Alternate Microphones
and Installation
Alternate Microphones and Installation
•
To wire the microphone cable to the plug provided, proceed as follows:
1.
Remove the retaining screw.
2. Unscrew the housing from the pin receptacle body.
3. Loosen the two cable clamp retainer screws.
4. Feed the microphone cable through the housing, knurled ring and
washer as shown Fig. 3B.
5. The wires must now be soldered to the pins as indicated in the wiring table.
If a vise or clamping tool is available, it should be used to hold the pin receptacle
body during the soldering operation so that both hands are free to perform the
soldering. If a vise or clamping tool is not available, the pin receptacle body can
be held in a stationary position by inserting it into the microphone jack on the
front panel. The numbers of the pins of the microphone plug are shown in Fig 4,
as viewed from the back of the plug. Before soldering the wires to the pins,
pre-tin the wire receptacle of each pin of the plug.
Be sure that the housing and the knurled ring of Fig. 3 are pushed back onto the
microphone cable before starting to solder. If the washer is not captive to the pin
receptacle body, make sure that it is placed on the threaded portion of the pin
receptacle body before soldering.
If the microphone jack is used to hold the pin receptacle during soldering operation,
best results are obtained when the connections to pins 1 and 3 are made first and
then the connections to pins 2 and 4. Use a minimum amount of solder and be
careful to prevent excessive solder accumulation on pins, which could cause a
short between the pin and the microphone plug housing.
6. When all soldering connections to the pins of the microphone are complete, push the
knurled ring and the housing forward and screw the housing onto the threaded portion
of the pin receptacle body. Note the location of the screw clearance hole in the plug
housing with respect to the threaded hole in the pin receptacle body. When the housing
is completely threaded into the pin receptacle body, a final fraction of a turn either
clockwise or counterclockwise may be required to align the screw hole with the
threaded hole in the pin receptacle body. When these are aligned, the retaining
screw is then screwed into place to secure the housing to the pin receptacle body.
7. The two cable clamp retainer screws should now be tightened to secure the
housing to the microphone cord. If the cutting directions have been carefully followed,
the cable clamp should secure to the insulation jacket of the microphone cable.
8. Upon completion of the microphone plug wiring, connect and secure the
microphone plug in the transceiver.
Fig. 2 Microphone cable preparation
Fig. 3 Microphone plug wiring
Your Mobile Radio Your Mobile Radio
3
2
4
1
Fig. 4 Microphone plug pin numbers viewed from rear of pin receptacle