Filter
Top Products
Page 8SKU 97427 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Electrical
Requirements
120 V~ / 60 Hz
3.55 No Load Amps / 710 Watts
Power Plug Type: 2-Prong, Polarized
Power Switch Type: Lockable for
continuous run
Motor RPM 16,500
Drill Bit Diameter 1/4” (Qty 2)
Maximum Drilling
Depth
1-7/16”
Width Between
Drilling Holes
1-5/16” (On Center)
Fence
Adjustments
22-1/2° / 45° / 67-1/2° / 90°
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
INITIAL SET UP
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
To Install The Drill Bits:
Rotate the two Chucks (18) so that 1.
their Hex Screws (19) are on top.
(See Figure A.)
Use the provided Hex Key (86) to 2.
loosen the two Hex Screws (19).
(See Figure A.)
Insert the shafts of the two Bits (17) 3.
(with at face of shank facing the
screw) fully into the two Chucks (18).
Secure the Bits (17) into the Chucks 4.
(18) by using the Hex Key (86) to
rmly tighten the Hex Screws (19).
(See Figure A.)
FIGURE A
(TOP VIEW)
CHUCK (18)
CHUCK (18)
HEX SCREW
(19)
HEX SCREW
(19)
To Adjust The Cutting Depth:
Move the Motor Base (16) as far back 1.
as it will go. (See Figure B.)
WARNING