Filter
Top Products
Page 11SKU 97427 For technical questions, please call 1-800-444-3353.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Inspection, Maintenance, and
Cleaning
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation.
BEFORE EACH USE, 2. check to make
sure the Bits (17) are rmly secured
in place, sharp, and free of cracks or
bends.
AFTER USE,3. clean external surfaces
of the tool with a clean, moist cloth
and mild detergent. Do not use
solvents.
WHEN STORING, 4. keep the tool and
its accessories in its Carrying Case.
Make sure to store the Carrying
Case in a clean, dry, safe location
out of reach of children and other
unauthorized people.
5. WARNING! If the supply cord of
this power tool is damaged, it must
be replaced only by a qualied
service technician.
TROUBLESHOOTING
Problem Possible Causes Possible Solutions
Tool will not start No power at outlet.1.
Cord not connected.2.
Check power at outlet.1.
Check that cord is plugged in.2.
Tool produces
unsatisfactory
cuts.
Bits not rmly secured.1.
Bits are dull.2.
Bits are cracked or bent.3.
Make sure Bits are rmly secured in the 1.
Chucks.
Use only sharp Bits.2.
Replace with new Bits.3.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT,
OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/
OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.