Filter
Top Products
16
Remote control cont.
Pairing
By default as well as the supplied remote the iD100 will
respond to any Apple remote.
The iD100 also supports the Apple pairing feature for
people with several Apple products (see Apples own
information on how this works).
You can pair the iD100 to a specific Apple remote by
pointing it at the iD100 and holding down the RIGHT and
MENU buttons for 6 seconds.
The iD100 will then respond to that Apple remote only (plus
its own supplied handset).
You can un-pair the iD100 again (will respond to all Apple
remotes) by pointing any Apple remote at the iD100 and
holding down the LEFT and MENU buttons for 6 seconds.
The above operations do not affect the operation of the
iD100s own supplied remote which always controls the
iD100 and uses its own code set.
The remotes supplied with some Cambridge Audio Azur
products also offer Apple codes and support the pairing
function (see their manual for details).
iPad and iD100 Remote Limitations
Currently the iPod feature of the Apple iPad does not allow
full browsing of content via accessories such as the iD100.
When in the iPod mode of the iPad the iD100 supports only
PLAY/PAUSE, BACK, FORWARD, REPEAT & SHUFFLE (all
basic transport commands).
This may change in future iPad software updates and is a
function of the iPad software rather than the iD100.