Filter
Top Products
Getting Started
Page 8 Sonido Radio
SETTING THE CLOCK
Please read this entire section carefully before you start.
The
clock can be set either while the radio is on or off. You will need
to go through the steps listed below without stopping for more
than 15 seconds at any given time or you will have to start over.
(Refer to page 4 for Button Identification.)
1) Press and hold the Scan/Set Button for three
seconds. You will hear a beep. The
HOUR DIGIT
and the symbol will flash on the display.
2) Using the Up/Down Tuning Buttons, select the
appropriate hour digit and AM or PM.
3) Press the Scan/Set Button again to select the
minutes digits, the
MINUTES DIGITS will flash.
4) Use the Up/Down Buttons to adjust the minutes to the
appropriate time.
5) You must press the Scan/Set Button again to complete the
time setting.
SETTING THE ALARM
There are two different alarm modes on the Sonido Radio. You
can choose to wake up to the radio or to a beep tone. You can
set the alarm with the radio on or off.
To set the type of alarm:
1) To wake with the Radio, press and hold the Radio
Alarm button (shown at right) for 2 seconds. The
symbol will flash, you will hear a beep and the
current alarm time will display.
To wake with the Beep Tone Alarm, press and hold the
Beep Tone Alarm button (shown at right) for 2 seconds.
The symbol will flash, you will hear a beep and the
current alarm time will display.
Continued on page 9
SCAN