Filter
Top Products
AUX IN Jack
The green jack, labeled AUX IN, is used to connect an external
audio source such as an MP3 Player, CD, or recorder, so you
can listen through your Sonido Radio’s speaker. To
do this, you will need the appropriate
patch cord. Refer to page 18 for
specifications.
With a patch cord
connected
, press the Step/Band
button until
AU appears on the dis-
play.
Radio Operation
Sonido Radio Page 17
2) By pressing Tuning Down, you may adjust the steps from
200kHz for U.S. or 100kHz per step for Europe.
3) After the FM step is selected, press the Step/Band button
again to bring up the AM step selections. The display
will show AM and flash 10 kHz tuning steps. By pressing
Tuning Down, you may adjust the steps from 10kHz to 9kHz
per step for Europe.
4) Complete the setting by pressing the Step/Band button once
again.
HEADPHONE JACK
You can use a stereo or mono headphone (located on the left
hand side of your radio) with a 3.5mm plug. When you insert
headphones into the headphone jack, the speaker is disconnect-
ed and this radio provides FM stereo through the headphones.
Note: If using a mono headphone jack or a single earphone
piece, the FM sound will be in mono. A limited number of
earpieces may not work properly. Call for advice.
Warning: If a "LINE OUT" is not available on your
external audio source, you can use the headphone
jack. However, the volume must be kept low or audio
distortion may result.
AUX In
Jack
Headphone
Jack