Filter
Top Products
724-746-5500 | blackbox.com
Page 12
10/100BASE-TX to 100BASE-FX Media Converter
To set the DIP switches:
1. First, disconnect the converter from the power. Then toggle Pin 2 of the DIP
switch to the up position to enable the forced mode for TX port.
NOTE: Pin 2 must be toggled up before setting speed and duplex mode manually.
2. Toggle down Pin 3 to force the TX port at the speed of 100 Mbps. Or toggle up
Pin 3 for 10-Mbps speed.
3. Toggle down Pin 4 to force the TX port at full-duplex mode. Or toggle up Pin 4
for half-duplex mode.
4. Toggle down Pin 5 to force the FX port at full-duplex mode. Or toggle up Pin 5
for half duplex mode.
5. Toggle up Pin 1 to disable the link-fault-pass-through.
6. Connect the converter to the power again. The new setting will then take effect.