Altec Lansing iMT702 Portable Speaker User Manual


  Open as PDF
of 20
 
4
Getting Started
How to Install the AC Adapter
1 Connect the AC adapter cable plug
into the speaker system’s jack.
The jack is located on the back of the
system.
2 Plug the AC adapter into the wall
outlet.
How to Charge the Lithium-Ion Battery
Your Altec Lansing inMotion Max speaker
system includes a rechargeable lithium-ion
battery. This battery should be fully charged
beforeinitialuseofthespeakersystem.Afullchargewillprovideupto3.5
hours of continuous playing time.
WhenthebatteryiconontheLCDscreendisplaysasinglesegment,you
should recharge the battery. When the battery icon starts flashing, the
speaker system is about to automatically shut down.
1 Connect the speaker system to a wall outlet.
SeetheHow to Install the AC Adapter section. The battery icon on
theLCDscreenwillshowthebatteryischarging.
2 Allow the battery to charge.
Chargingtime:Upto3hoursforafullcharge.Whenthebatteryis
fully recharged, the battery icon is shown as full.
WARNING During the recharging process, it is typical for the battery
to become warm. To be safe, keep flammable materials away from the
speaker system.
How to Disconnect the Rechargeable Battery
If you need to replace the lithium-ion battery, you will need to first remove it.
1 Unplug the speaker system from the wall outlet.
2 Remove the rechargeable battery compartment cover.
The battery compartment is located on the back of the speaker
system.Removethe2screwssecuringthecoverinplace.Then
remove the cover.
3 Unplug the battery and remove it.
NOTE The lithium-ion battery must be properly recycled or disposed of.
Please contact your local recycling center for proper battery handling and
disposal instructions.
How to Install the Enhanced Remote Battery
Theenhancedremotebattery(included)isnotinstalledatthefactory.To
install the battery, follow the steps below:
1 Pull out the battery holder.
The battery door is located on the
lowerendoftheremote.Simplypull
the tab to open the battery holder.
2 Position the battery (included) so it
sits in the battery holder correctly.
Makesurethepolarity(the+and–sidesofthebattery)iscorrect.
3 Replace the battery door.
NOTE Please discard used batteries properly.
 previous next