Altec Lansing iMT702 Portable Speaker User Manual


  Open as PDF
of 20
 
15
Troubleshooting
Symptom Possible Problem Solution
iPhone or iPod didn’t charge
iPhone or iPod is not installed properly RemoveyouriPhoneoriPodfromthedockandcheckforobstructionsonthe
connectors in the dock and on your iPhone or iPod. Then reseat it in the dock.
iPhone or iPod is locked up Please make sure your iPhone or iPod is working properly before docking into
the unit. Please refer to your iPhone or iPod manual for details.
ACadapterisn’tpluggedintoawalloutlet,
or the connector is not plugged into the
power supply jack on the back of the
speaker system
PlugtheACadapterintoawalloutletandplugtheconnectorintothesupply
jack on the speaker system.
Soundisdistorted
Volume level is set too high Decrease the volume.
Soundsourceisdistorted IftheiPhoneoriPodoriginalsoundsource(MP3)isofpoorquality,distortion
and noise are easily noticed with high-power speakers. Try a different audio
sourcesuchasamusicCD.
Enhanced remote doesn’t
work
Batteryisweak Replacecurrentbatterywithanewbattery.
Enhanced remote is not pointed toward
the speaker system
Point the enhanced remote toward the Altec Lansing speaker system and
movewithin10feetoftheunit.
No sound from the AUX
device,suchasanMP3
playerorCDplayer
connected to the AUX jack
Volume on the device is set too low Increase the volume on the device to approximately ¾ full volume.
SourceselectorisnotsettoAUX SetsourceselectortoAUX.
 previous next