Altec Lansing iMT702 Portable Speaker User Manual


  Open as PDF
of 20
 
12
Whenever your iPhone or iPod is docked and your Altec Lansing inMotion
MaxspeakersystemispluggedintoanACoutlet,youriPhoneoriPodis
charging(untilfullycharged)–evenifthespeakersystemisswitchedoff.
Listening to the FM Radio
1 Plug the FM radio antenna into the
speaker system’s FM ANTENNA
jack.
The jack is located on the back of the
system.
2 Extend the FM antenna wire fully
for best FM reception. Also, do
not strip, alter or attach to other
antennas.
3 Select “FM” mode.
Press the
button on your speaker system or enhanced
remote until the
appearsontheLCD.
4 Tune to the station you want to listen to.
Use the
and buttons on your speaker system or enhanced
remote to tune in the desired station. Press and hold these same
buttonstondthenextclearFMstation.
5 Adjust the volume.
Usethe+and–buttonsontheAltecLansingspeakersystem
toadjustthesystemvolume.Or,usethe+and–buttonsonthe
enhanced remote.
How to Store Preset Stations
Your Altec Lansing speaker system’s enhanced remote enables you to
programupto4FMstationpresets:
1 Tune to the station you wish to store.
Whilein“FM”mode,usethe
and buttons on your speaker
system or enhanced remote to tune to the desired station.
2 Store the station.
PressandholdtheP1,P2,P3orP4buttonontheenhancedremote
forafewseconds.YoucanstoreoneFMstationineachpreset.
3 To store other stations, repeat the above steps.
How to Recall Preset Stations
1 Make sure you are in “FM” mode.
Ifyou’renotin“FM”mode,pressthe
button on your
speaker system or enhanced remote until the
appearsontheLCD.
2 Press a PRESET button (P1, P2, P3 or P4) on the enhanced
remote.
The radio will tune to your preset station.
3 Adjust the volume.
Usethe+and–buttonsontheAltecLansingspeakersystem
toadjustthesystemvolume.Or,usethe+and–buttonsonthe
enhanced remote.
Charging Your iPhone or iPod
 previous next