FEED Key Self Test
See Figure 31.
1. Turn off the printer.
2. Press and hold the FEED key while
turning on the power.
3. Release the key after the DATA
light turns off (approximately
five seconds).
The FEED key self test prints out at
various darkness settings above and
below that of the darkness value shown
on the configuration label. Look at
these labels and determine which one
has the best darkness setting for your
application. This value can be entered
into the printer by setting the darkness
during the configuration procedure.
Refer to page 40 for more information.
The value printed on that label is added to (plus) or subtracted from (minus) the
darkness value specified on the configuration label. The resulting numeric value
(0 to 30) is the best darkness value for that specific media/ribbon combination.
76 Zebra Z4M Printer User’s Guide
Figure 31
