PAUSE Key Self Test
This self test can be used to
provide the test labels required
when making adjustments to the
printer’s mechanical assemblies.
See the sample printout in
Figure 30.
1. Turn off the printer.
2. Press and hold the PAUSE
key while turning on the
power.
3. Release the key after the
DATA light turns off
(approximately five
seconds).
n
The initial self test prints 15 labels at 2"/51 mm per second, then automatically
pauses the printer. Each time the PAUSE key is pressed, an additional 15 labels
print.
n
While the printer is paused, pressing the CANCEL key alters the self test. Now
each time the PAUSE key is pressed the printer prints 15 labels at 6”/152 mm per
second.
n
While the printer is paused, pressing the CANCEL key again alters the self test
again. Each time the PAUSE key is pressed the printer prints 50 labels at
2”/51 mm per second.
n
While the printer is paused, pressing the CANCEL key again alters the self test a
third time. Now each time the PAUSE key is pressed the printer prints 50 labels at
6”/152 mm per second.
n
While the printer is paused, pressing the CANCEL key again alters the self test a
fourth time. Each time the PAUSE key is pressed the printer prints 15 labels at the
printer’s maximum speed.
n
To exit this self test at any time, press and hold the CANCEL key.
Zebra Z4M Printer User’s Guide 75
Figure 30
