_____________________________________ Macintosh Setup 3-17
Note: When you add a printer from the network, go through either
the Auto Setup or manual setup procedure to ensure that the
printer is recognized by the network.
Configuring the Printer
If necessary, configure the printer’s communication interface using
the front panel. See Chapter 6, “Configuration,” for details.
1. Select the SETUP:I/F menu.
2. Select the menu for the printer interface connected to your
computer (LTALK or ETALK).
3. Select the ENABLE menu. Then, select YES.
4. Press the Reset key until READY/IDLE appears.
5. Verify the setup.
a. Make sure your Macintosh is connected to the printer
with a LocalTalk or Ethernet cable.
b. Double-click the XANTÉ Command Center icon in the
XANTÉ Utilities folder.
c. Choose General: Printer Status. A dialog box displays
the current printer status.
Note: If the status dialog box does not appear, check
all cable connections and be sure the printer
interface you are using is enabled on the printer.
d. Click OK in the dialog box. Choose File: Quit to close
Command Center.
