ENG
ADVANCED OPERATION
29
2-3-1 Projector Settings
Projector Setting selections
Use ▲ and ▼ to navigate Selections of Projector Settings Sub-Menu (Fig. 2-3-1)
Press to confirm the Sub-Menu selection.
Press to go to previous menu.
AUTO SOURCE
ON
FIXED SYNC
OFF
AUTO
SHUTDOWN
OFF
LAMP MODE
NORMAL
DAYLIGHT
SENSOR
AUTO
PROJECTION
FRONT/DESK
Fig. 2-3-1
Projector Settings Sub-Menu
Automatically select the next active input source
Select ON to enable the feature; OFF to disable the feature
Use default timing data stored in the projector instead of
consistent auto sync sampling. Auto sync will cause incorrect
image sizing If the on-screen image has black border. The
problem is further complicated if the source content’s screen
resolution is not consistent.
Select ON to enable the feature; OFF to disable the feature
AUTO
SHUTDOWN
5 15 30 45 60 OFF
Automatically shut down the projector after standby 5 / 15 /
30 / 45 / 60 minutes or feature off.
Select lamp power efficiency mode
Normal: Standard mode, maximum lumen and power output
Eco: Reduced power, less fan noise, and lamp life can be
extended.
DAYLIGHT
SENSOR
AUTO MANUALOFF
Adjust the viewing condition based on ambient light environment
OFF: Disable the feature
Auto: Enable the feature and adjust automatically
Manual: Enable the feature and adjust manually
Manually choose the light rate.
Low: Dim environment
Middle: Average light environment
High: Bright environment
PROJECTION
FRONT / DESK REAR / DESK
FRONT / CEILING REAR / CEILING
Projection method selections
Use ▲ and ▼ to choose the right projection method.
