A4 Galaxy II Operating Manual
This kit is designed to replace a coin door with two coin slots
with a coin door that has one coin slot and a Mars AE2451 or
AE2651 Series bill acceptor. The AE2451 bill acceptor
accepts One and Five dollar bills. The AE2651 bill acceptor
accepts One, Five, Ten and Twenty dollar bills. The bill
acceptor is not provided.
Parts included are:
P/N Description
41952 Metal door with opening for bill acceptor
41884 Harness for one coin and bill acceptor
41926 Power cable for bill acceptor
38180 Ferrite suppressor, split donut
41951 Instructions (this page)
17035 Nylon wire tie (2)
WARNING - UNPLUG GAME
BEFORE STARTING!
1. Remove the existing coin door by removing the four
screws on the coin door hinge.
2. Remove one coin slot and lock from the door just
removed and attach to the new coin door.
3. Install the Mars AE2400 Series bill acceptor (not
provided).
4. Attach P/N 41884 wire harness to the new door (see
picture #1). The small beige 9-pin connector goes to
the bill acceptor. The two-wire bundle with a blue
wire and a black with red stripe (the longest two) go
to the lamp above the reject button. The next shorter
pair, gray with black stripe and black with red stripe,
goes to the coin switch. There are two green wires
that go to the ground stud on the inside of the coin
door close to the hinge.
5. Insert the three wires from P/N 41926-power cable
into existing Main Harness connector (in the coin
door area) as shown in picture #2. Make sure that
you hook up these wires correctly! These are the 120
VAC to the bill acceptor.
Bill Acceptor Door Kit For The Galaxy II
P/N 41950
Picture #1
TO COIN SWITCH
TO COIN
DOOR LAMP
FERRITE SUPPRESSOR
TO MAIN HARNESS
CONNECTOR
TO BILL ACCEPTOR
TO COIN
DOOR GROUND
TO MAIN HARNESS
TO POWER
SUPPLY
FRONT AC
CONNECTOR
