Galaxy II Operating Manual 7
Adjust Network Speed: Used to set the network
transmission speed. If Galaxy or Black Widow
machines are networked with Galaxy II machines, the
network speed must be set to 9600. If only Galaxy II
machines are networked, any speed can be used, but
they all must be set to the same speed.
Network Monitor: Displays all network data sent by
the machine in yellow and all network data received in
white.
Network Send Test: Tests the ability of the machine
to send data across the network. (Displays the alpha-
bet in yellow as the characters are being sent.) Used in
conjunction with another machine running the
Network Receive Test (see below) to verify network
communications. Red characters indicate a problem.
Network Receive Test: Tests the ability of a machine
to receive data across the network. (See Network Send
Test above.) When another machine is set up to send.
the receiving machine will display the alphabet in
white letters as they are being received. Red
characters indicate a problem.
Network Help: Displays frequently used information
on network setup for the technician.
Direct Connect: Used to connect a PC directly to the
Galaxy II through the network. For configuration and diag-
nostic purposes only.
D. Reports
Game Popularity Counter: Displays a history of machine
usage. Shows all games on the machine, the number of
times each game was played and the number of credits col-
lected toward each game.
Coin Slot Report: Displays the number of credits taken in
by each of the coin slots - individually.
Credits Report: Used by the collector to display credits
taken in (since last reset) for game play and league dues.
E. Hardware Test/Software Update Menu
Hardware Test/Software Update Menu
System Info: Provides hardware and software version
information.
Hardware Test Menu: Allows technician to check
the operation of inputs and outputs.
Receive RS-485 Software Update: Used to update
software Eproms from a PC. See Appendix A.
Send RS-485 Software: Used to copy the software
from one networked Galaxy II to another Galaxy II
that has been set to Receive RS-485 Software Update.
Only one Galaxy II machine can be set to receive on
the network at a time. See Appendix A.
Port-A-Flash Software Update: Used to manually
update the software from a Port-A-Flash instead of
using the beginning update screen.
Reboot: Used to exit the Software Update Menu and
reboot the machine.
Duplicate Boot Flash (To Eprom 1): Copies the software
contents of Eprom 0 to Eprom 1. See Appendix A.
Update Boot Flash (From Eprom 1): Copies the software
contents of Eprom 1 to Eprom 0. See Appendix A.
Stuck Segment History: Shows the most recent history of
stuck segments. This is useful for troubleshooting player
complaints of miss darts and stuck segments.
View Boot Log: This opens a report that shows the recent
history of the Galaxy II being turned off and on.
D.
Send Info and Settings to Network:
Sends League Files and Machine settings to the Galaxy
II’s on the network.
Section 5
Technical Description
5.1 General Information
5.2 Power Supply
The machine is equipped with a switching power supply.
This supply has a universal 85 VAC to 264 VAC 50/60 HZ
input. The inputs connect to J1, and the outputs are on J2.
J1
Pin 1 AC Line
Pin 2 AC Neutral
J2
Pin 1 +12 VDC
Pin 2 +5 VDC
Pin 3 Unused
Pin 4 Logic Ground
Pin 5 Logic Ground
Pin 6 -12 VDC-Not Used
5.3 Main PC Board
The main PC board is controlled with a Motorola ColdFire
5206e microprocessor and associated IC's consisting of the
following:
