SY-D6IBA2
Quick Start Guide
Note: Installing a heat sink and cooling fan on top of your CPU is necessary for
proper heat dissipation. Failing to install these items may result in overheating
and possible burn-out of your CPU.
Step 2. Make Connections to the Motherboard
This section tells how to connect internal peripherals and power supply to the Motherboard.
Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Chassis Fan,
Front Panel Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock
Switch.), Wake-On-LAN card, VGA card, Sound Card, and other devices.
For more details on how to connect internal and external peripherals to your new SY-
D6IBA2 Motherboard, please refer to SY-D6IBA2 Motherboard User's Guide and Technical
Reference online manual on CD-ROM.
Connectors and Plug-ins
PCI Audio Card Header: SB-Link™ (PC-PCI) Wake-On-LAN Header: JP44
Pin1 Pin2 Pin3
Connect the SB-Link™ (PC-PCI) cable from your PCI audio
card to this header.
5VSB GND MP-Wakeup
Slot 1 #1 CPU
Cooling Fan: FAN 1
Slot 1 #2 CPU
Cooling Fan: FAN 2
Chassis Fan: FAN 3
Pin1 Pin2 Pin3 Pin1 Pin2 Pin3 Pin1 Pin2 Pin3
GND 12V SENSOR GND 12V SENSOR GND 12V SENSOR
Power LED Keylock
Pin1 Pin2 Pin3
Pin1 Pin2
5V NC GND
Control Pin GND
Speaker
Pin1 Pin2 Pin3 Pin4
5V NC NC Speaker out
HDD LED Turbo LED PWRBT RESET
Pine1 Pin2 Pin1 Pin2
Pin1 Pin2
Pin1 Pin2
LED Anode
LED
Cathode
LED
Cathode
GND
Power
On/Off
GND
Power
Good
GND
IrDA (Infrared Device Header): IR1
Pin1 Pin2 Pin3 Pin4 Pin5
VCC None IRRX GND IRTX
ATX Power On/Off: PWRBT ATX Power Supply: ATX PW
Connect your power switch to this
header (momentary switch type).
To turn off the system,
please press this switch and hold
down for longer than
4 seconds.
Attach the ATX Power cable to this connector.
When using the Power-On by PS/2 Keyboard
function, please make sure the ATX power supply
can take at least 720mA load on the 5V Standby lead
(5VSB) to meet the standard ATX specifications.
Power LED
Speaker
+
+
++
_ _
_
_
