Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
200
Interface Parameters
Wireless Interface Parameters
The wireless interface group parameter is wif. The wireless interface uses table index 3.
Common Parameters to 802.11a and 802.11b/g
* For 802.11a APs certified in the ETSI and TELEC regulatory domains and operating in the middle frequency band, disabling Auto Channel
Select will limit the available channels to those in the lower frequency band.
† Wireless Service Status cannot be shut down on an interface where Rogue Scan is enabled.
‡ Distance Between APs allows the AP to perform better in high noise environments by increasing the receive sensitivity and transmit defer
threshold, as follows:
Name Type Value Access CLI Parameter
Wireless Interfaces Group N/A R wif
Table Index Integer 3 R index
Operational Mode Integer 1 = dot11b-only
2 = dot11g-only
3 = dot11bg
4 = dot11a
5 = dot11g-wifi
RW mode
Network Name DisplayString 1 - 32 characters
My Wireless Network (default)
RW netname
Auto Channel Select
(ACS)*
Integer enable (default)
disable
RW autochannel
DTIM Period Integer 1 - 255
1 = default
RW dtimperiod
RTS/CTS Medium
Reservation
Integer 0 - 2347
Default is 2347 (off)
RW medres
MAC Address PhyAddress 12 hex digits R macaddr
Wireless Service Status
†
Integer 1 = resume
2 = shutdown
RW wssstatus
Supported Frequency
Channels
Octet String Depends on Regulatory Domain R suppchannels
Load Balancing Max
Clients
Integer 1 - 63 RW lbmaxclients
Distance Between APs
‡
Integer 1 (large) (default)
2 (medium)
3 (small)
4 (minicell)
5 (microcell)
RW distaps
AP Link Length** Integer 200 - 45000 RW aplinklength
Transmit Power Control Integer enable
disable
RW txpowercontrol
Transmit Power Control
Back-Off
Integer 0 - 35 (dBm) RW currentbackofftpcvalue
Antenna Diversity Integer 1 (Antenna 1)
2 (Antenna 2)
5 (Auto; both antennas)
(See Configure Antenna Diversity)
RW atdiversity
