PRV-9000 Operating Instructions
1. Place a disc in the recorder.
The disc may be playing, paused or stopped. If the disc is playing, the
picture appears in the lower right corner of the screen.
2. Press SHIFT on the remote control.
3. Press PROGRAM (7
on the number pad).
4. Enter the track number for this Program List.
For track: press 8 on the number pad then press Enter
For track 16: press 1 and 6 then press Enter
5. Press ENTER after each complete track number.
6. Continue entering all sequences for this List.
7. Press PLAY to begin playback of the Program List tracks.
To play the List at a later time, press SHIFT, then PROGRAM to exit
the menu.
To view the Program List, press SHIFT then PROGRAM on the remote
control.
To add a pause between List entries, press the PAUSE button instead of a
number button then press ENTER to add the pause. If there is already a
number in that space, all entries after that point are forced down one step in
the List. Add pauses anywhere except as the first step or the last step in a
Program List. After a pause, press PLAY to continue playback.
To delete an entry from the Program List, position the cursor over the entry
then press CLEAR. All following entries move back by one step. To delete a
Program List stop the disc playback then press CLEAR. Unless the Program
List is stored in the recorder’s memory, the List is also erased when the disc
is removed or the recorder’s power is turned OFF (standby mode).
To insert an entry within a Program List, position the cursor over the desired
slot and enter the title/chapter/track. Press ENTER to store the entry and to
force all following entries to advance by one step.
To cancel a playing Program List without stopping the disc playback, press
CLEAR. The disc continues playing from the current sequence.
To add a currently playing title/chapter/track to the Program List, press SHIFT
then hold down the PROGRAM button for at least two seconds. If a Program
68
