33
• DHCP Client Protocol
• If enabled, the NetCam2 automatically sets all addresses by detecting
them from the DNCP server. The detected addresses are not shown on
the screen.
• If disabled, the administrator must configure all information on network
addresses.
• Select Network Interface
• Select 'Ethernet' if the NetCam2 is connected with Internet via a
dedicated line, cable modem line or LAN environment.
• Select 'xDSL(PPPoE)' if NetCam2 is connected to an xDSL line that
needs a PPPoE process to connect to Internet.
• Select PSTN(Dial Out) if NetCam2 is connected on a network with a
PSTN modem.
Ethernet Interface
• IP Address – enter IP address.
• Subnet mask – enter Subnet mask address.
• Broadcast Address – click on ‘Get From Netmask’ button after assigning the
IP address and Network Mask address and the broadcast address is
automatically set.
Note: If addresses are incorrectly assigned, the NetCam2 cannot be accessed.
• DNS Server IP Address – this is used when NetCam2 is registered on the
dynamic IP registration list of the Netcam registration server.
NetCam2 Section 4
