and the settings including the network settings will be initialized. Do not turn off the power of the unit
about 6 minutes after turning on the power.
:
To initialize the network settings (®page 166), turn off the power of the camera, then turn on the power
again while holding down the [INITIAL SET] switch on the unit, and keep the [INITIAL SET] switch held
down for about 5 seconds. Wait about 3 minutes after releasing the button. The camera will start up
and the settings including the network settings will be initialized. Do not turn off the power of the unit
about 3 minutes after turning on the power.
:
To initialize the network settings (®page 166), do the following. Turn off the power of the camera. Turn
on the power of the camera after setting the [INITIAL SET] button to ON, and wait about 6 minutes.
The camera will start up and all the settings including the network settings will be initialized. After
initialization, turn off the power of the camera again and set the [INITIAL SET] button to OFF. Do not
turn off the power of the camera about 6 minutes after turning on the power.
:
To initialize the network settings (®page 166), do the following. Turn off the power of the camera. Turn
on the power of the camera after setting the [INITIAL SET] button to ON, and wait about 3 minutes.
The camera will start up and all the settings including the network settings will be initialized. After
initialization, turn off the power of the camera again and set the [INITIAL SET] button to OFF. Do not
turn off the power of the camera about 3 minutes after turning on the power.
•
:
The notification function allows users to provide the notification of the error to the specified destination
address and an original alarm destination when an error such as no SD memory card insertion after
the reboot or a locked SD memory card insertion occurs. (®page 147, page 148)
Operating Instructions 221
20 Maintenance of the camera [Maintenance]
