The description below is the configuration of the priority stream that can transmit images without deteriorating
the image quality and refresh interval even when multiple users access concurrently.
Priority stream
[Activation]
Select “On” or “Off” to determine whether or not to use the priority stream.
• Default: Off
Note
• When “On” is selected for “Activation” of “Priority stream”, number of users who can access the camera
may be limited.
[Destination IP address(1)]
Enter the first destination IP address.
[Destination IP address(2)]
Enter the second destination IP address.
[Stream type]
Select either “JPEG”, “H.264/MPEG-4(1)” or “H.264/MPEG-4(2)”.
• JPEG: JPEG images will be transmitted.
• H.264/MPEG-4(1): H.264(1) (or MPEG-4(1)) images will be transmitted.
• H.264/MPEG-4(2): H.264(2) (or MPEG-4(2)) images will be transmitted.
• Default: JPEG
Note
• When “Best effort” is selected for “Transmission priority” of “H.264 (MPEG-4)”, bit rate will vary between
the maximum and minimum rates while images are being transmitted.
:
• When “H.264” is selected for “Recording format”, it is impossible to transmit H.264(2) images. In this
case, “H.264/MPEG-4(2)” is invalidated.
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when “JPEG” is selected for “Stream type”.
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps/ 10fps/ 12fps*/ 15fps*/ 30fps*
Operating Instructions 159
15 Configure the settings relating to the authentication [User mng.]
