Chapter 6 Hardware Installation
53
Step 5 Set Jumpers
Make sure the jumper settings on the MegaRAID card are correct. The jumpers and connectors
are:
Connector Description Type
J1 Channel B Internal Wide SCSI 68-pin connector
J2 Channel A Termination Enable 3-pin header
J3 Channel B Termination Enable 3-pin header
J4 Channel A Internal Wide SCSI 68-pin connector
J5 Channel C Termination Enable 3-pin header
J6 SCSI activity LED 4-pin header
J7 Channel D Termination Enable 3-pin header
J9 Channel A TERMPWR Enable 2-pin header
J10 Channel B TERMPWR Enable 2-pin header
J11 Channel C TERMPWR Enable 2-pin header
J12 Channel D TERMPWR Enable 2-pin header
J13 Channel A/B External Wide SCSI Dual 68-pin connector
J14 Serial port connector 9-pin connector
J18 Serial EEPROM Port 2-pin header
J19 Onboard BIOS Enable 2-pin header
J22 Channel C/D External Wide SCSI Dual 68-pin connector
J23 External battery connector 5-pin connector
MegaRAID Enterprise 1600 64-Bit 160M Card Layout
Cont’d
