Operating the Seamless Switcher / Scaler
31
Table 5: Infra-red Remote Control Transmitter Functions
Keys Function
OUT Selects the output resolution and illuminates the appropriate LED
FREEZE Pauses the output video
POWER Cycles power
INPUT SELECTOR*
7 separate keys for selecting each of the following sources: AV1, AV2,
COMP. (Component) YC1, YC2, VGA, and DVI
INFO. Defines the main source, whether mute is activated, output mode, as well
as the firmware version number
PRESET POSITION
CONTROL
1
Adjusts the zoom
2
position
3
AUTO IMAGE Assesses the image and improves the quality accordingly, by automatically
adjusting the phase, frequency and position
MENU Displays the OSD Menu screen
4
and locks/unlocks the front panel
5
NAVIGATION CONTROL
6
Allow maneuvering within an OSD screen (all keys); adjusts the zoom
position (4 keys)
AUTO GAIN Automatically adjusts the brightness and contrast
SWAP Not applicable
7
PIP Not applicable
8
CONT. Displays the contrast status
9
BRIGHT. Displays the brightness status
9
AUDIO/ZOOM CONTROL
6
Allow volume and zoom control
MODE Toggles between each of the following modes:
Normal, Presentation, Cinema, Nature, User 1 and User 2
SCALE Toggles between each of the following Aspect Ratios:
Normal, Wide Screen, Pan & Scan, 4:3 Output, and 16:9 Output
10
* Press to select the source; the LED illuminates. Press again to freeze
the image; the LED flashes. Press once again to display a blank screen;
the LED flashes more slowly.
1 Consists of a set of 9 separate keys. See the illustration in Figure 42 which shows an enlarged view of this part of the
Infra-red remote control transmitter
2 A small rectangle inside a transparent pop-up OSD Enlarge status box appears at the top right corner of the screen showing
the position of the zoom within a picture
3 For example, when enlarging the display, press this button:
to go to the lower right corner of the display area
4 As Figure 8 illustrates
5 See section 6.2
6 Consists of a set of 5 separate keys. See the illustration in Figure 42 which shows an enlarged view of this part of the
Infra-red remote control transmitter
7 Not available on the VP-719DS (to toggle between the PIP content and the screen source content). Available on machines
such as the VP-720DS
8 Not available on the VP-719DS (to select the picture-in-picture function). Available on machines such as the VP-720DS
9 Adjust using the +/- keys
10 See Figure 16
