Connecting the Seamless Switcher / Scaler
7
5 Connecting the Seamless Switcher / Scaler
Using the VP-719DS you can select any one of the 7 inputs and scale that
input to the output at the set
1
resolution.
To connect the VP-719DS, connect the following
2
to the rear panel, as the
example in Figure 3 illustrates:
1. Connect one or more of the following video sources:
• 2 composite video sources, “Composite Video Source 1” and “Composite
Video Source 2”, to the RCA connectors CV 1 and CV2, respectively
3
• 2 s-Video sources: “s-Video Source 1” and “s-Video Source 2”, to the 4p
connectors, YC 1 and YC 2, respectively
• A component video source
4
, for example, a Betacam VCR (as illustrated
in Figure 3), to the 3 RCA connectors, Y, P
b/
C
b
, and P
r/
C
r
5
• A VGA graphics source, for example, a PC with an analog graphics
output, to the VGA HD15F connector
• A DVI graphics source, for example, a PC with a digital graphics output,
to the DVI connector
2. Connect the stereo audio sources, as illustrated in Figure 3. In particular:
• The audio of the “Composite Video Source 1” to the AUDIO INPUT
VIDEO 1 pair of RCA connectors
6
• The audio of the “s-Video Source 2” to the AUDIO INPUT VIDEO 2 pair
of RCA connectors
7
• The audio of the Component video source, the Betacam VCR, to the
AUDIO INPUT COMPONENT pair of RCA connectors
• The audio of the DVI Graphics Source to the AUDIO INPUT PC 3.5mm
socket
8
. Alternatively, connect the audio from the VGA Graphics Source (not
illustrated in Figure 3)
1 For details of how to set the output resolution, refer to section 6.1
2 Switch OFF the power on each device before connecting it to your Seamless Switcher / Scaler. After connecting your
Seamless Switcher / Scaler, switch on its power and then switch on the power on each device
3 Connection to CV 2 is not shown in the example in Figure 3
4 Sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb, Pr
5 Alternatively, you can connect an RGB signal (not shown in Figure 3), as follows: RED to the “Y” connector, GREEN to
the “Pb/Cb” connector, and BLUE to the “Pr/Cr” connector
6 The VIDEO 1 connectors are common to CV 1 and YC 1
7 The VIDEO 2 connectors are common to CV 2 and YC 2
8 The PC connector is common to DVI and VGA
