In a “subscriber controlled processing system”, the input frequency of
the receiver is a fi xed setting. The “subscriber controlled processing
system” transmits the signals at this frequency. The reception
parameters for programme selection are communicated to the
receiving system by a DiSEqC™ command and set.
The setting that has to be selected depends on the design of the
“subscriber controlled processing system”.
” menu option to “On”, use this menu
mini” menu option to “On”, use this menu mini
option to make the setting from the transmission frequency.
For the transmission frequency to be set, refer to the installation
manual for the “subscriber controlled processing system”.
is essential that you follow the instructions in the
controlled processing system
The setting for this menu option is also designed for operation of the
receiver in a processing system.
The return path of the coaxial cable is used for control and
communication between the receiver and the Kathrein UFO
The return path of the coaxial cable is used for control and
®
The return path of the coaxial cable is used for control and
system. If the receiver is operated in a UFO
system. If the receiver is operated in a UFO
®
system. If the receiver is operated in a UFO
” menu option must be set to “On”.
The receiving system then assigns the receiver a special address upon
installation, so that it will recognise the control commands sent by the
receiver to the receiving system for signal selection.
In this operating mode, a remote frequency need not be set, as it is
In this operating mode, a remote frequency need not be set, as it is
®
In this operating mode, a remote frequency need not be set, as it is
system with the addressing.
If the receiver is being used in a UFO
fi rst time, the address previously assigned must be deleted. This is
fi rst time, the address previously assigned must be deleted. This is
®
fi rst time, the address previously assigned must be deleted. This is
” menu option by selecting “Reset” using the
keys. The receiver is then assigned the original factory
setting. It then needs to be set to “On” again. The receiver receives its
new address from the new system.
This item allows all parameters to be reset to the factory settings using
key. The factory settings do not necessarily correspond to the
settings required for your specifi c system.
After resetting, you may need to make all settings again.
