Setting System Parameters
With the factory setting, the receiver indicates the “UTC” (United Time
Coordinate, previously Greenwich Mean Time), which is transmitted
with the data stream. For Germany, the time must therefore be correc-
To do this, move the cursor bar to the “Local Time/Timer” menu option
To do this, move the cursor bar to the “Local Time/Timer” menu option
To do this, move the cursor bar to the “Local Time/Timer” menu option
keys to correct the time for-
wards or backwards in half-hourly intervals.
If the time displayed by the receiver differs from the correct time by just
a few minutes, proceed as follows:
keys to go to the “Local Time/Timer” menu
option and change the time by approx. 10 hours (forwards) using
option and change the time by approx. 10 hours (forwards) using
option and change the time by approx. 10 hours (forwards) using
to switch the receiver to
Standby mode, and disconnect it briefl y from the power supply for a few
seconds using the power switch.
- Start up the receiver again and, from the main menu, switch to the
“System Parameters” sub-menu and then to the “Local Time/Timer”
- If necessary, correct the time in half-hourly intervals with the
keys until the correct time is displayed.
twice takes you back to the normal TV picture.
Help for the selected item
keys to specify whether your TV set is a
twice takes you back to the normal TV picture.
keys to select the type of picture format for
which your TV set is designed. This will either be
twice takes you back to the normal TV picture.
turn this time setting on
initially turn off the receiver with
not initially turn off the receiver with not
remote control for this pur-
pose, as otherwise the settings will
