Table 29. Configuration Parameter List - LEN End Node LU Name
Parameter Information
Parameter
fully-qualified LU name
Valid Values
fully-qualified (explicit) LU name Generic (partially explicit) LU name Wildcard entry
A string of up to 17 characters in the form of
netID.LUname
, where:
v
netID
is a network ID from 1 to 8 characters
v
LUname
is a control point name from 1 to 8 characters
Each name must conform to the following rules:
v First character: A to Z
v Second to eighth characters: A to Z, 0 to 9
Note: An existing fully-qualified LU name, using the special characters @, $, and #
from the character set A, continues to be supported; however, these characters should
not be used for new LU names.
To reduce the number of fully-qualified LU names you need to specify, you can define a
generic LU name using the wildcard character (*) to represent a portion of the LU name
(
LUname
). You can also define a wildcard entry by using the wildcard character as the
whole LU name.
Default Value
None
Description
This parameter specifies the fully-qualified names of LUs associated with a LEN end
node. The specified LU names are registered in the network node’s directory services
database. If a name is not registered, the network node cannot locate the LU (unless
the LU name is the same as the CP name of the LEN end node).
You need to specify a fully-qualified LU name, which consists of a network ID and the
LU name. The network ID is the name of the network that contains the adjacent LEN
end node. The LU name is the name of a logical unit accessible through the adjacent
LEN end node.
Syntax:
add
connection-network
You will be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
APPN Configuration Commands
Chapter 2. Configuring and Monitoring APPN 173
