57
Lubrication
7. Replacing the engine’s oil filter
1. Remove the oil filter. If necessary, use a filter
remover.
2. Clean the oil filter’s mounting.
3. Wipe new, clean engine oil onto the seal for the
new filter.
4. Fit the filter by hand until it mates + 3/4 turns.
5. Run the engine warm, then check that there are no
leaks around the oil filter seal.
6. Check the oil level in the engine, top up if
necessary. The oil filter holds 0.2 litres of oil.
8. Hydraulic oil
Viscosity and quality
Hydraulic oil ISO VG.
Viscosity 46 cSt.
Local regulations may affect the choice of hydraulic oil
due to environmental reasons, consult your Husqvarna
workshop at the relevant location.
Inspection off the oil level
Open the right-hand engine cover and check the level
against the level marking. The level should be between
the MAX and MIN line.
Filling hydraulic oil
Remove the engine cover. See “Engine cover” on
page 79. Fill with hydraulic oil to approximately 60 mm
(2 1/4”) below the strainer’s upper edge.
WARNING:
IMPORTANT INFORMATION:
Risk of spray and burn injuries. The engine’s oil
filter may be very hot immediately after stopping.
Allow the engine to cool somewhat first.
Replaced filters must be handed in to the workshop
or other allotted place for disposal.
Avoid skin contact; wash with soap and water in case
of spills.
Oil level, hydraulic tank
