22
Presentation
26. Starter switch
Three positions:
• OFF
All functions switched off. The engine is stopped. The
parking light can be switched on (traffic kit option).
•ON
Normal operating position.
• Start and Preheating
Keep the switch in the glow plug mode, when glow
plug heating is complete the starter is engaged.
During glow plug heating, light (43) on the indicator
panel comes on. Non-locking to position ON.
Turning again within 2 seconds gives starting
without glow plug heating.
27. Headlight
Three positions, clockwise in the following order:
• Off:
• Dipped beam
• Full beam
If the switch is moved to the Dipped beam position
automatic dipped beam mode, dipped beam is
switched on when the engine is running.
28. Throttle control
The accelerator is used to control the speed of the engine
and thereby also the rotation speed of the blades.
In order to increase or decrease the engine speed, the
control is moved forwards or backwards respectively.
29. High speed
Activated switch. This switch is used to select either
high or low speed.
The speed must drop to zero before the machine shifts
to low speed if high speed is actuated.
If the differential lock is actuated, the machine will not
shift to high speed until the pedal is released.
Front wheel drive is engaged in high speed mode.
All wheel drive is engaged in low speed mode.
The differential lock and cutting unit only work in low
speed mode.
Starter switch
Switch for headlight
