Caution Check that you are using the correct print cartridges. Also, note that
HP does not recommend modifying or refilling HP cartridges. Damage that
results from modifying or refilling HP cartridges is not covered by the
HP warranty.
For best print quality, HP recommends that you install all retail print cartridges before
the date stamped on the box.
Insert or replace the print cartridges
Remove the pink tape
Do not touch here
Prepare the printer and cartridges
1. Make sure the power is on and you have
removed the cardboard from inside the printer.
2. Lift the main cover of the printer.
3. Remove the bright pink tape from all cartridges.
Do not touch the ink nozzles or the copper-colored
contacts, and do not re-tape the cartridges.
Insert the cartridges
1. If you are replacing a cartridge, push down and
pull outward on the cartridge stall cover to
open it and then pull the cartridge out.
2. Match the symbol on the cartridge label to the
correct stall. Hold the cartridge with the label
on top and slide it at a slight upward angle into
the stall so the copper-colored contacts go in
first. Push the cartridge until it snaps into place.
3. Close the cartridge stall cover.
4. Repeat the previous steps to install the other
cartridges, if necessary.
5. When you are finished installing cartridges,
close the main cover.
HP Photosmart 8400 series Reference Guide 15
