EPSON FX-2180 Service Manual Chapter 5 Adjustments
5-5
5.2.2.1 Performing the Bi-d Adjustment Using the Settings
Diskette
1.
Make sure the PC is turned off. Insert the Settings diskette into drive A
of the PC and turn on the PC.
2.
Exit Windows and go to the DOS prompt.
3.
At the DOS prompt, type
GWBASIC J10a72v.bas
and press
Enter
.
You see the Printer Select menu.
Program : J****** Setting : *****
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Printer select ]
> (1) 9 pins
(2) 24 pins
Figure 5-5. Printer Select Menu
4.
Use the
↑
or
↓
key to highlight
9 pins
and then press
Enter
. You see
the Setting File menu.
Program : J****** Setting : ******
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Setting File ]
> (1) DEFSTD
(2) EURSTD
(3) NLSP
(4) ITALIC
(5) RUSSIAN
Figure 5-6. Setting File Menu
5.
Use the
↑
or
↓
key to highlight the factory setting for the printer’s
destination and press
Enter
. Refer to Table 5-3 for destination settings.
Table 5-3. Destination Settings
Destination Setting Destination Setting
EAI USASTD EAI (Latin) USASTD
EIRO EURSTD EDG EURSTD
EUL EURSTD EUL
(SCANDINAVIA)
EURSTD
EFS EURSTD EIS EURSTD
EIB EURSTD EDG (NLSP) NLSP
EUL (MIDDLE
EAST)
DEFSTD EAL DEFSTD
ESP DEFSTD EHK DEFSTD
After you select the destination setting, you see the Main menu.
Program : J****** Setting : *****
9 pins VR 0 = 0 VR 1 = 0 VR 2 = 0
[ Main MENU ]
> (1) Bi-d Adjust (6) Envelope
(2) FF paper (7) ---- N/A ----
(3) A3 Cut sheet (8) -- SUB MENU
(4) A4 1P Cut sheet
(5) A4 6P Cut sheet
Figure 5-7. Main Menu
6.
Use the
↑
or
↓
key to highlight
Bi-d Adjust
and press
Enter
.
