A SERVICE OF

logo

Open as PDF
next previous
Problem
Solution
The position of the
printout is not
what you expected.
(continued)
Line spacing is not
correct.
One line of printing
has taken up two
lines.
Your software may be set up incorrectly.
Use your programs setup (or install)
program to check the settings on the
computer’s display. If your application
program is capable of sending control
codes, use the line spacing commands
listed in Chapter 9, The Command
Summary.
The margin settings may not be set
correctly. Use your application program
settings to change the margins. If your
program allow it, you can also set the
left and right margins using the ESC I n
and ESC Q n commands. Refer to 9-20. If
you are using BASIC, enter either of the
following statements:
WIDTH LPRINT 255
WIDTH “LPTI” 255
Troubleshooting 7-11