Printing
Problem
. .
Solution
The printout is not
what you expected.
(continued)
Graphic characters
(line, ect.) being
printed instead of the
selected italic
characters.
Characters not
belonging to the
selected international
character set being
printed.
The character font or
character spacing
selected by
SelecType
cannot be printed.
The wrong character table may be
selected. If your application program is
capable of sending control codes, specify
the Italic character table using ESC t 0. If
settings cannot be performed using
control codes, set the CG TABLE option
of SelecType to Italic. Refer to 3-14.
The wrong international character set is
selected. If your application program is
capable of sending control codes, specify
the desired international character set
using ESC R n. If settings cannot be
performed using control codes, set the
COUNTRY option of SelecType to the
desired character set. Refer to 3-35.
Your software may be overriding your
SelecType settings. Use the program’s
setup (or install) procedure to check the
printer settings on your computer’s
display, then reset the values correctly.
7-8 Troubleshooting
