A SERVICE OF

logo

Open as PDF
next previous
Always turn the power OFF (with the switch on the right side of
the printer) before you change the setting of any of these switches.
Any changes made while the power is on will be ignored until you
turn the printer off and back on. So set all switches with the power
off.
In Table D-l we show you the functions of all the switches. Then
we explain each of them.
Table D-I. DIP switch functions
Switch 1
No. ON
Functions
OFF
1-8
ON
International character set
OFF
1-7
ON
International character set
OFF
1-6
ON
International character set
OFF
1-5
Inactive
Paper-out sensor
Active
1-4
12-inch
Form length
11-inch
1-3
Active
Cut-sheet feeder
Inactive
1-2
Char. graphics
Character set
Italics
1-1
Condensed
Print width
Pica
Switch 2
No. ON Functions OFF
2-4
Mute
Beeper
Sounds
2-3
CR + LF
Automatic line feed
CR only
2-2
Active
Printer-select
Inactive
2-1
0
Slashed zero
0
Note:
The shaded boxes show the factory settings.
Switches l-6, l-7, and l-8 determine the active international character
set as shown in Table D-2.
Table D-2. International DIP switch settings
Country
Switch 1-6
Switch 1-7
Switch 1-8
USA
On
On
On
France
On On
On
Germany
On
Off
On
United Kingdom
On
Off
Off
Denmark
Off
On
On
Sweden
Off
On Off
Italy
Off Off
On
Spain Off
Off
Off
The use of international sets is discussed in Chapter 6.
D-2