Testing the Printer
Part of a typical pattern 1 test print is shown below:
After the page has been printed, the printer returns to the main
menu and the display shows TEST PRINT.
If you want to print the second test print pattern, follow these
additional steps:
4. Press I,( once; then change the test pattern number by
pressing or once to display the following:
5. Press I,( to print the second pattern.
After you print the test pattern, press SelecType once to exit
SelecType mode.
If the test pattern prints correctly, you can skip to the section on
connecting the printer to your computer later in this chapter. If the
test print does not operate properly, see Chapter 7 for
troubleshooting information.
2-12
Testing and Connecting Your Printer
