A SERVICE OF

logo

HP Emulation
Removing
a font cartridge—To remove a font cartridge, follow these
steps:
1.
Press the
ON LINE
button to set the printer off line.
CAUTION: Never insert or remove
the
cartridge while the
printer is on line.
2.
Hold the edges of the cartridge and slowly pull it from the slot.
3.
Press
the ON LINE
button to set the printer on line.
Reset
In HP emulation mode, you can reset
the
printer in the following
three ways:
l
By turning
the
power off and then back on
l
By holding down
the CONTINUE/RESET
button for three seconds
(with
the printer off line)
l
By sending the ESC E command.
The result varies depending upon
which
method you use, as shown
in the table on
the
next page.
Printer Modes 5-5