7
N530T 1/00
© 2000 Directed Electronics, Inc.
Dipswitch #5 controls the polarity that the 530T switch input wires will respond to. For type A and type C
systems, it must be set to the OFF (+) position. When the switch is in the off position the 530T responds to (+)
positive inputs on its switch wires. If your vehicle has a type B system, this switch must be set to the ON (-)
position, so the 530T will respond to (-) negative inputs on its switch wires. Remember, the type B system
switches its wires to (-) ground rather than (+)12V.
When mounting the control module, always locate it as close to the window motor as possible. The driver-side kick
panel is an ideal location. If “one-touch” operation from the passenger-side switch is desired, interface with the
passenger-side wires between the passenger-side switch and the motor. This usually requires the passenger-side wires
to be extended and run into the passenger-side door. When extending the wires, use no smaller than 14 gauge wire.
IMPORTANT! Do not mount the control module in the vehicle door, as water damage will result. The
best results are obtained by mounting the control module inside the vehicle, as close to the window
motor as possible, in one of the kick panels.
To roll the windows up:
Simply arm the vehicle security system. The windows will roll up completely.
To arm the security system and leave the windows down:
1. Press the auxiliary channel.
2. Within 5 seconds arm the security system.
3. The security system will arm, but the windows will remain down.
To vent the windows:
At any time, press and release the auxiliary channel. The windows will vent about two inches.
To roll the windows down:
At any time, press and hold the auxiliary channel for three seconds. The windows will roll all the way down.
To activate “one-touch” operation:
1. Turn on the ignition.
2. Tap the power window switch in either direction. The window will open or close completely.
To stop the window:
1. Turn on the ignition.
2. Tap the power window switch in either direction while the window is in motion.
Operating Instructions
Mounting the Control Module
Switch Input Polarity ON (-) OFF (+)
Switch 5
