3-37
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
Chapter 3 Configuring Open Shortest Path First (OSPF)
Showing OSPF Information
Showing the Configured Advertised ASE Routes
To show the configuration of ASE routes into OSPF, enter:
# show ospf advertise
To show the configuration of ASE routes into OSPF for a specific host, include
the IP address or host and the subnet mask. Enter the address in dotted-decimal
format (for example, 192.168.11.1) or mnemonic host-name format (for example,
myname.mydomain.com). Enter the mask either:
• As a prefix length in CIDR bit-count notation (for example, /24). Do not enter
a space to separate the IP address from the prefix length.
• In dotted-decimal notation (for example, 255.255.255.0).
For example:
# show ospf advertise 192.168.11.1/24
Table 3-8 describes the fields in the show ospf advertise command output.
Table 3-8 Field Descriptions for the show ospf advertise Command
Field Description
Prefix The IP address for the route. For the CSS, the prefix is
predominately VIP addresses.
Prefix Length The prefix length for the IP address.
Metric The network cost for the route. The range is from 1 to
16777215. The default is 1.
Type The ASE type for the route. By default, the ASE type is ASE
type2, which is the external cost to reach the route. ASE type1
combines the external and internal costs.
Tag The 32-bit tag value to advertise the route. The value is not used
by OSPF.
