Chapter 3 Configuring Open Shortest Path First (OSPF)
Showing OSPF Information
3-28
Cisco Content Services Switch Routing and Bridging Configuration Guide
OL-4580-01
To set the retransmission interval to 10 seconds, enter:
(config-circuit-ip[VLAN6-3.1.2.2])# ospf retransmit 10
To reset the retransmit interval to the default value of 5 seconds, enter:
(config-circuit-ip[VLAN6-3.1.2.2])# no ospf retransmit
Setting the Transit-Link Delay
Transit delay is the estimated number of seconds the CSS waits to transmit a
link-state update packet over the OSPF interface. Use the ospf transit-delay
command to set the transit delay for an interface. Enter a number from 0 to 3600
seconds (1 hour). The default is 1 second.
To set the transit delay to 3 seconds, enter:
(config-circuit-ip[VLAN6-3.1.2.2])# ospf transit-delay 3
To reset the transit delay to the default value of 1 second, enter:
(config-circuit-ip[VLAN6-3.1.2.2])# no ospf transit-delay
Showing OSPF Information
Use the show ospf command to view OSPF information on the CSS. This
command is available in all modes. This section includes the following topics:
• Showing OSPF Area Information
• Showing Global Statistics
• Showing IP Interface Information
• Showing Link-State Databases
• Showing ASE Entries
• Showing the Configured Advertised ASE Routes
• Showing the Redistribution Policy
• Showing Summary Route Configuration Information
• Showing OSPF Neighbors
