Send documentation comments to mdsfeedback-doc@cisco.com
3-8
Cisco MDS 9020 Fabric Switch Configuration Guide and Command Reference
OL-6988-02
Chapter 3 Initial Configuration
Initial Setup Routine
Using the setup Command
To make changes to the initial configuration at a later time, you can enter the setup command in EXEC
mode.
Note The setup utility is mainly used for the initial configuration when no configuration is present. The setup
utility assumes system defaults and not the current system configuration values.
switch# setup
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup always assumes a predefined defaults irrespective
of the current system configuration when invoked from CLI.
Press Enter in case you want to skip any dialog. Use ctrl-c at anytime
to skip away remaining dialogs.
Would you like to enter the basic configuration dialog (yes/no): yes
The setup utility guides you through the basic configuration process.
