Send documentation comments to mdsfeedback-doc@cisco.com
3-7
Cisco MDS 9020 Fabric Switch Configuration Guide and Command Reference
OL-6988-02
Chapter 3 Initial Configuration
Initial Setup Routine
Step 10 Enter no (no is the default) to disable the SSH service.
Enabled SSH service? (yes/no) [n]: no
Step 11 Enter no (no is the default) to not configure the NTP server.
Configure NTP server? (yes/no) [n]: no
Step 12 Enter noshut (shut is the default) to configure the default switchport interface to the noshut state.
Configure default switchport interface state (shut/noshut) [shut]: noshut
Step 13 Enter deny (deny is the default) to deny a default zone policy configuration.
Configure default zone policy (permit/deny) [deny]: deny
Deny prevents traffic flow to all members of the default zone.
Step 14 You see the new configuration. Review and edit the configuration that you have just entered. Enter no
(no is the default) if you are satisfied with the configuration.
The following configuration will be applied:
username admin password admin_pass role network-admin
switchname switch
interface mgmt0
ip address ip_address subnet_mask
ip default-gateway 10.0.0.254
telnet server enable
no ssh server enable
no system default switchport shutdown
no zone default-zone permit
Would you like to edit the configuration? (yes/no) [n]: no
Step 15 Enter yes (yes is default) to use and save this configuration:
Use this configuration and save it? (yes/no) [y]: yes
Caution If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type yes to save the new configuration and ensure that the system
images are also automatically configured. (See Chapter 4, “Software Images”.)
