2-11
Cisco SIP IP Phone 7960 Administrator Guide
78-10497-02
Chapter 2 Getting Started with Your Cisco SIP IP Phone
Installing the Cisco SIP IP Phone
Manually Configuring the SIP Parameters
If you did not configure the SIP parameters via a TFTP server, you must manually
configure them after you have connected the phone as described in the
“Connecting the Phone” section on page 2-16.
Before You Begin
•
Connect your phone as described in the “Connecting the Phone” section on
page 2-16.
•
Unlock configuration mode as described in the “Unlocking Configuration
Mode” section on page 3-2. By default, the SIP parameters are locked to
ensure that end-users cannot modify settings that might affect their call
capabilities.
•
Review the guidelines on using the Cisco SIP IP phone menus documented in
the “Using the Cisco SIP IP Phone Menu Interface” section on page 2-21.
•
When configuring the Preferred Codec and Out of Band DTMF parameters,
press the Change soft key until the option you desire is displayed and then
press the Save soft key.
•
After making your changes, relock configuration mode as described in the
“Locking Configuration Mode” section on page 3-2.
•
For a complete list of the SIP parameters that you can configure, see the
“Modifying the Phone’s SIP Settings” section on page 3-5.
Procedure
Step 1
Press the settings key. The Settings menu is displayed.
Step 2
Highlight SIP Configuration. The SIP Configuration menu is displayed.
Step 3
Highlight Line 1 Settings.
Step 4
Press the Select soft key. The Line 1 Configuration menu is displayed.
