Cisco IE 3010 Switch Getting Started Guide
24
Cisco IE 3010 Switch Getting Started Guide
78-19582-02
Troubleshooting
Express Setup
If Express Setup does not run or if the Express Setup page does not appear in your
browser:
Did you verify that POST
completed before you started
Express Setup?
If not, make sure that only the system and
port LEDs are green before you press the
Express Setup button.
POST errors are usually fatal. Contact your
Cisco technical support representative if your
switch fails POST.
Did you press the Express Setup
button while the switch was still
running POST?
If yes, wait until POST completes. Restart
the switch. Wait until POST completes.
Confirm that the system and port LEDs are
green. Press the Express Setup button.
Does your PC have a static IP
address?
If yes, change your PC settings to
temporarily use DHCP.
Did you connect the Ethernet
cable to the console port instead
of to a blinking 10/100 Ethernet
port on the switch?
If yes, disconnect the cable from the console
port on the switch. Connect the cable to a
blinking 10/100 Ethernet port on the switch.
Wait 30 seconds, and start a browser session
on the PC.
Note The console port is outlined in blue,
and the Ethernet ports are outlined in
yellow.
Did you wait 30 seconds after you
connected the switch and the PC
and before you started a browser
session on the PC?
If not, wait 30 seconds before you start a
browser session on the PC.
