Configuring Spanning Tree
Defining Rapid Spanning Tree
ESW 500 Series Switches Administration Guide 287
• Point-to-Point Operational Status — Indicates the Point-to-Point operating
state. The possible values are:
- Enable — Enables Point-to-Point on the interface.
- Disable — Disables Point-to-Point on the interface.
• Activate Protocol Migration — Click the Activate button to run a Protocol
Migration Test. The test identifies the STP mode of the interface connected to
the selected interface.
STEP 2 Define the relevant fields.
STEP 3 Click Apply. The Rapid Spanning Tree Settings are defined, and the device is
updated.
Modifying RTSP
STEP 1 Click VLAN & Port Settings > Spanning Tree (STP) > RSTP. The
RSTP Page
opens:
STEP 2 Click the Edit button. The
Edit Rapid Spanning Tree Page
opens:
Edit Rapid Spanning Tree Page
The
Edit Rapid Spanning Tree Page
contains the following fields:
• Interface — Specifies whether Rapid STP is enabled is enabled on a port or
EtherChannel.
