2-28
Catalyst 6500 Series Switch SSL Services Module Command Reference
OL-9105-01
Chapter2 Commands for the Catalyst 6500 Series SSL Services Module
interface ssl-proxy
The valid values for configuring HSRP are as follows:
• group-number—(Optional) Group number on the interface for which HSRP is being activated; valid
values are from 0 to 255 for HSRP version 1; valid values are from 0 to 4095 for HSRP version 2.
See the “standby version” section on page 2-116 for information about changing the HSRP version.
If you do not specify a group-number, group 0 is used.
• ip ip-addr—Specifies the IP address of the HSRP interface.
• priority priority— Specifies the priority for the HSRP interface. Increase the priority of at least one
interface in the HSRP group. The interface with the highest priority becomes active for that HSRP
group.
• prempt —Enables preemption. When you enable preemption, if the local router has a hot standby
priority that is higher than the current active router, the local router attempts to assume control as
the active router. If you do not configure preemption, the local router assumes control as the active
router only if it receives information indicating that no router is in the active state (acting as the
designated router).
• delay—(Optional) Specifies the preemption delay. When a router first comes up, it does not have a
complete routing table. If it is configured to preempt, it becomes the active router but cannot provide
adequate routing services. You can configure a delay before the preempting router actually preempts
the currently active router.
[no] shutdown Shuts down the subinterface. Use the no form of this command to put the
subinterface in service.
standby [group-number] {authentication
text string} | {delay minimum [min-delay]
reload [reload-delay]} | {ip [ip-address
[secondary]]} | {mac-address mac-address}
| {mac-refresh seconds} | {name
group-name} | {preempt [delay{minimum
delay | reload delay | sync delay}]} |
{priority priority} | {redirects [enable |
disable] [timers advertisement holddown]
[unknown]} | {timers [msec] hellotime
[msec] holdtime} | {track object-number
[decrement priority]} | [version
{1 | 2}]
Configures redundancy on the subinterface. See the following commands for
valid values:
• standby authentication
• standby delay minimum reload
• standby ip
• standby mac-address
• standby mac-refresh
• standby name
• standby preempt
• standby priority
• standby redirects
• standby timers
• standby track
• standby use-bia
• standby version
timeout absolute minutes seconds Sets the session timeout values for this interface. Valid values for minutes are
from 0 to 71582787 minutes. Valid values for seconds are from 0 to 59
seconds.
Table 2-1 Subinterface Configuration Submode Command Descriptions (continued)
Syntax Description
