1-3
Cisco Catalyst Blade Switch 3030 Getting Started Guide
78-17052-01
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Taking Out What You Need
• Regulatory Compliance and Safety Information for the Cisco Catalyst Blade
Switch 3030
• Registration card
Follow these steps:
1. Unpack and remove the switch module and the accessory kit from the
shipping box.
2. Return the packing material to the shipping container, and save it for
future use.
Note If the switch modules are ordered with the server chassis, the switch modules are
already installed, and no unpacking is required. The unpacking procedure applies
only if a switch module is ordered separately.
Cisco Gigabit Ethernet Switch Module Description
Figure 1 shows the switch module, which has these features:
• 10 internal Gigabit Ethernet 1000BASE-X ports
• 1 console port
• 2 external 10/100/1000BASE-T copper Gigabit Ethernet ports
• 4 external small form-factor pluggable (SFP) module uplink ports that
support 1000BASE-SX fiber and 10/100/1000BASE-T copper (only Cisco
SFP modules are supported)
Each port has an LED associated with it. Additionally, there is a System
Status/ID LED that is controlled by the Dell Remote Access Controller/Modular
Chassis (DRAC/MC) management board.
