1-23
Cisco Catalyst Blade Switch 3030 Getting Started Guide
78-17052-01
Cisco Catalyst Blade Switch 3030 Getting Started Guide
In Case of Difficulty
To reset the switch:
• At the switch prompt, enter enable and press Return or Enter.
• At the Privileged EXEC prompt, switch#, enter setup and press
Return or Enter.
The switch displays the prompt to run the initial configuration dialog. See the
“Configuring the Switch Module” section on page 1-9 to re-enter the
configuration information and set up your switch.
Accessing Help Online
First look for a solution to your problem in the troubleshooting sections of the
hardware installation guide or the software configuration guide for your switch on
Cisco.com. You can also go to the Cisco Technical Support and Documentation
website for a list of known hardware problems and extensive troubleshooting
documentation, including:
• Factory defaults and password recovery
• Recovery from corrupted or missing software
• Switch port problems
• Network interface cards
• Troubleshooting tools
• Field notices and security advisories
Follow these steps:
1. Open your browser, and go to http://www.cisco.com/.
2. Click Technical Support and Documentation.
3. Click Product Support > Switches > LAN and ATM Switches > Cisco
Gigabit Ethernet Switch Module > Troubleshooting.
4. Click the subject that addresses the problem that you are experiencing.
