Printer-Applicator-System PAM 3000C-2
Fig. C-5 Interface cable with 9 pin computer connector for RS-232 with protocol
"RTS/CTS" or "XON/XOFF"
Fig. C-4 Interface cable with 25 pin computer connector for RS-232 with protocol
"RTS/CTS" or "XON/XOFF"
PC Printer
25 pin connector 25 pin plug
11
23
32
45
54
77
6
8
20
PC Printer
9 pin connector 25 pin plug
22
33
57
75
84
1
4
6
Interface Cable for RS-422 / RS-485
To control the printer by RS-422/ RS-485 interface, only the signals TDATA+, TDATA-,
RDATA+, and RDATA- are necessary.
Check the pin assignment for the interface of your computer, and use the pin assignment of
the printer as shown in table C-1 to obtain a suitable cable. The connectors of TDATA+ and
RDATA+ as well as TDATA- and RDATA- at the plug-in-connection of the cable must be
united. If there is a very large transfer distance a termination of the cables is recommended.
PC Printer
22
33
57
820
14
45
6
Fig. C-3 Interface cable with 9 pin computer connector for RS-232 with protocol
" ---" or "XON/XOFF"
9 pin connector 25 pin plug
